4.2 Processing part programs from external CNC systems
Note
Default setting
For
SINUMERIK 828D, the following machine data are already suitably preset for the particular
technology – either turning or milling. These machine data cannot be changed and are not
displayed.
Activate the ISO Dialect function
The MD18800 $MN_EXTERN_LANGUAGE machine data is used to activate the external
language. The ISO dialect M or T language types can be selected using MD10880
$MN_EXTERN_CNC_SYSTEM.
The two G commands
of group 47 are used to switch from Siemens mode to ISO dialect mode:
● G290: Siemens NC programming language active
● G291: ISO dialect NC programming language active
The active tool, tool offsets and work offsets are retained. G290 and G291 must be the only
components of an NC program block.
The switchover to an external programming language is contained in the scope of delivery for
SINUMERIK 828D. MD10712 $MN_NC_USER_CODE_CONF_NAME_TAB is only valid for
NC language commands in the Siemens mode.
References
Function Manual ISO Dialects
Parameterizing machine data
4.2 Processing part programs from external CNC systems
CNC commissioning
80 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
To Next Page
Loading...
Need help?
General
