Siemens SINUMERIK 828D

6.2.3 How to start the automatic servo optimization
Starting automatic servo tuning
Procedure:
1. Ensure that the axis to be tuned is in a safe position. If this is not the case, traverse the
axis in JOG mode to the center of the travel path:
2. To confirm, press "OK". The prompt to press <CYCLE START> on the machine control
panel then appears:
3UHVV1&67$57WRFRQWLQXHRUSUHVV0&35HVHWWR
FDQFHOWKHPHDVXUHPHQW
$FDQFHOOHGPHDVXUHPHQWFDQEHSDUDPHWHUL]HGDJDLQ
DQGUHVWDUWHG
0HDVXUHPHQW
3OHDVHFRQILUPWKHVWDUWRIWKHPHDVXUHPHQWLQ
FKDQQHO&+$1ZLWK1&67$57RQWKH
PDFKLQHFRQWUROSDQHO
Tuning
6.2 Automatic servo optimization
CNC commissioning
176 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3