Siemens SINUMERIK 828D

<REASON4>
<Text value="TM_DGL_PREMATURE_WEAR" type="QString" />
<BitMask value="8" type="int" />
</REASON4>
<REASON5>
<Text value="TM_DGL_TYPE_REEQUIPPING" type="QString" />
<BitMask value="16" type="int" />
</REASON5>
<REASON6>
<Text value="TM_DGL_TOOL_TRIAL" type="QString" />
<BitMask value="32" type="int" />
</REASON6>
<REASON7>
<Text value="TM_DGL_PREVENTIVE_CHANGE" type="QString" />
<BitMask value="64" type="int" />
</REASON7>
</TOOLCHANGEREASON>
See also
For configuring new parameters, see
Configuring list parameters (Page 249).
9.2.24 Configure the code carrier connection
Requirement
Software option
You require the "Access MyTool ID" option for this function (Tool Ident Connec‐
tion).
<IDENTCONNECTIONCONFIGURATION> tag
The entries used for
configuring the code carrier connection in the tool list of the user interface
are located in the <IDENTCONNECTIONCONFIGURATION> tag. The code carrier
connection is implemented via TDI Ident Connection.
Tool management
9.2 Configuring the user interface
SINUMERIK Operate
284 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3