Siemens SINUMERIK 828D

2.2.7 Registering the COM file in easyscreen.ini
Adaptation in easyscreen.ini
Make
the following change in the easyscreen.ini in the OEM directory. You have thus registered
the diag.com configuration file.
;########################
;# AREA Diagnosis #
;########################
;<===============================================================>
;< OEM Softkey on first horizontal Main Menu >
;< SOFTKEY position="7" >
;<===============================================================>
StartFile28 = area := AreaDiagnosis, dialog:= SlDgDialog, menu := DgGlobalHu, startfile := diag.com
2.2.8 Testing the project
Testing the dialog call
Switch to the diagnostics operating area. Click the "START" horizontal softkey.
If "Run MyScreens" detects errors when interpreting the configuration files, these errors are
stored in the easyscreen_log.txt text file (see Chapter
Troubleshooting (log book) (Page 31)).
Testing context sensitive help screens and online help
Test the context sensitive help screens and the online help. If errors occur, then check the
paths where files have been saved.
Getting Started
2.2 Example
SINUMERIK Integrate Run MyScreens
24 Programming Manual, 10/2015, 6FC5397-3DP40-5BA3