9.3 Dialog selection via NC
MMC command in HMI Operate
You can use MMC commands as described in the following:
1. Definition of MMC commands
The following is available in the standard systemconfiguration.ini file.
Combinations:
address:=MCYCLES --> command:=LM
address:=CYCLES --> command:=PICTURE_ON
This distinction is necessary in order to differentiate between measuring cycles and other
cycles. This means that:
– LM
is always applicable for measuring cycles, PICTURE_ON, always for non-measuring
cycles
– It is not permissible that newly defined MMC commands are designated PICTURE_ON
and LM
2. "Run MyScreens" license
All the dialogs opened by "Run MyScreen", with the exception of measuring cycles, fall
under the "Run MyScreens" license, which means that without license, only a limited
number of dialogs can be used.
Example call with test.com (Run MyScreens):
g0 f50
MMC("CYCLES,PICTURE_ON,test.com,screen form1","A")
m0
MMC("CYCLES,PICTURE_OFF","N")
M30
Dialog selection
9.3 Dialog selection via NC
SINUMERIK Integrate Run MyScreens
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3 197
To Next Page
Loading...
Need help?
General
