Siemens SINUMERIK 828D

C.3.2 Structure of the scene description file
The
structure of the scene description file is shown below together with an explanation of the
relevant XML commands:
Design and description
<!-- Treatment of the plane-dependent texts for turning -->
<TextPlane plane="G18_ZXY" />
Description
<TextPlane plane="G18_ZXY" /> Treatment of the plane-dependent texts (axis
names)
specifically for turning. If, for example,
a text with the identifier "Z" is used (for G18 first
geometry axis), the corresponding geometry
axis identifier of the control will be shown in the
help screen (for example, "Z").
<!--Text alignment -->
<TextPosition center='true' />
Description
<TextPosition center='true' /> Marking that the texts are centered. This is rel‐
evant to the display of the texts in rotated
screens. We recommend using this setting.
<!--Adapting the tool speed -->
<ToolSpeedFactors planeSpeedFactor="0.4" rapidSpeedFactor="0.7"
reducedSpeedFac¬tor="1.0"/>
Description
<ToolSpeedFactors This entry can be added if the tool speeds are
to be modified.
planeSpeedFactor="0.4" Factor for the feedrate ( 0.4 = 40% )
rapidSpeedFactor="0.7" Factor for rapid traverse ( 0.7 = 70% )
reducedSpeedFactor="0.1" /> Factor for a third speed ( 0.1 = 10% )
Animated elements
C.3 XML commands
SINUMERIK Integrate Run MyScreens
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3 219