Siemens SINUMERIK 828D

<!--Definition of an animation-->
<SceneKey name='BoringAnimation' masterRotationSpeed="-64.0"
maxRotAngle="45.0" begin-Time='0.110 endTime='0.118 view='camiso'
speedMaster='boringtool' Type="VIEW_3D_TURN_CYL">
Description
<SceneKey name='BoringAnimation' Name of the animation
masterRotationSpeed="-64.0" Direction of rotation and rotation speed of the
tool.
The setting is optional.
maxRotAngle="45.0" To avoid aliasing effects (tool seems to be turn‐
ing
in the wrong direction). The value is usually
a fourth of the symmetry of the tool.
The setting is optional.
beginTime='0.110 Start time of the animation on the time sensor
endTime='0.118' End time of the animation on the time sensor
view='camiso' Camera to be used for the animation
speedMaster='boringtool' Name of the tool for the animation
type="VIEW_3D_TURN_CYL"> View type defines the view (see Section View
type
(Page 222))
<!-- Elements -->
<Element name='1' time='0.110' feed='rapid' dwell=’2’/>
<Element name='2' time='0.112' feed='rapid'/>
<Element name='3' time='0.114' feed='rapid'/>
<Element name='4' time='0.116' feed='plane'/>
<Element name='5' time='0.118' feed='plane'/>
Description
<Element name='1' Specifies that it is the first element of the ani‐
mation.
time='0.110' Time of the first element on the time sensor
feed='rapid' Traversing speed of the element
plane = machining feedrate
rapid = rapid traverse
reduced = reduced speed, slower than "plane"
dwell=’2’/> Pause in the traversing motion of the anima‐
tion. A rotating tool continues to rotate.
Animated elements
C.3 XML commands
SINUMERIK Integrate Run MyScreens
220 Programming Manual, 10/2015, 6FC5397-3DP40-5BA3