Siemens SINUMERIK 828D Commissioning Manual

5.6.3 Remove data set
Precondition
To remove data sets, the following conditions must be met:
● Number of DDS > 1 in the MDS ⇒ DDSes can be removed.
● Number of MDS > 1 ⇒ MDSes can be removed.
Commissioning the drive
5.6 Configuring data sets
CNC commissioning
162 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash