Siemens SINUMERIK 828D - Configuring the User Interface

9.2 Configuring the user interface
Configurable settings
The following settings can be configured:
●
General settings
●
Configuring the tool lists
●
Configuring the list parameters
●
Configuring the tool types
● Configuring the "Additional Data" window
● Configuring the "New Tool - Favorites" window
● Configuring the "New Tool" window
● Configuring the "New Multitool" window
● Configuring the "New Tool from Code Carrier" window
● Configuring the "New Tool from File" window
● Configuring the default values for new tools
● Configuring the "Details" window
● Assigning names for magazines and magazine locations
● Configuring the "Assign Tooltips for Multitool Locations" window
● Assigning names for magazine location types
● Assignment of magazines and magazine locations to channels
● Assignment of magazines to coordinate systems
● Disabling the softkey depending on filters
● Configuring the "Load Station Selection" window
● Coolant and tool-specific functions
● Reason for the tool change when reactivating
● Configuring the code carrier connection
● Configuring store to file
The following sections explain how you configure these adaptations.
Procedure
1. Open the directory: /siemens/sinumerik/hmi/template/cfg.
2. Copy the "oem_sltmlistconfig.xml" template file
3. Copy the file to the directory /oem/sinumerik/hmi/cfg
OR: /user/sinumerik/hmi/cfg.
Tool management
9.2 Configuring the user interface
SINUMERIK Operate
228 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3