EasyManuals Logo

Siemens SINUMERIK 828D Commissioning Manual

Siemens SINUMERIK 828D
1167 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #905 background imageLoading...
Page #905 background image
Testing the connection
3
Requirement
To test the connection, you can use the "Sample Applications" of the OPC Foundation (http://
www.opcf.org/) under "Developer Tools/Developer Kits/Unified Architecture". It is necessary
to register with the OPC Foundation for this.
Note
There are two ways to establish the connection:
Connection without security
Connection with the security policy "Basic128Rsa15" and the security mode
"SignAndEncrypt"
Installation
The "Sample Applications" additionally install a service with the name "OPC UA Local
Discovery Server". Should you want to locally test the OPC UA connection, i.e. an installation
directly on the PCU 50, you must deactivate this service.
Note
If the service "OPC UA Local Discovery Server" is active, the SINUMERIK OPC UA server
cannot be started correctly, because it blocks the needed TCP port 4840.
The service has no influence if the "Sample Applications" are installed on a PC in the network.
Deactivation is then not necessary.
SINUMERIK Integrate for Engineering Access MyMachine / OPC UA
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 13

Table of Contents

Other manuals for Siemens SINUMERIK 828D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 828D and is the answer not in the manual?

Siemens SINUMERIK 828D Specifications

General IconGeneral
Control TypeCNC
Operating SystemWindows Embedded
ProcessorIntel Atom
Display10.4" color TFT display
InterfacesEthernet, USB
ProgrammingShopMill, ShopTurn
Operation Panel Size10.4"
Protection ClassIP65
PLC Memory2 MB
Spindle Capacity4 spindles
Hard DriveCompactFlash

Related product manuals