Siemens SINUMERIK 828D

1.5 To select the cylindrical/surface grinding technology, proceed as
follows:
Selecting the grinding technology
During
the
control
startup,
the startup menu provides the option to change the technology from
cylindrical grinding to surface grinding or vice versa.
To switchover the grinding technology, select it again in the startup menu. The default data is
then loaded and the desired technology scaled. The licenses and options are retained.
Switching between surface grinding and cylindrical grinding
Procedure:
1. After the control is switched on, the following is displayed:
2. The default setting during startup is "Normal startup": Press the <SELECT> key.
3. To call the "Startup menu", press the following keys in succession:
Menu back key, HSK2 (horizontal softkey 2), VSK2 (vertical softkey 2)
Note
PPU with touch operation
To call the Startup menu during startup, there is an additional shortcut for all PPUs: "8" →
"2" → "8"
Scope of delivery and requirements
1.5 To select the cylindrical/surface grinding technology, proceed as follows:
CNC commissioning
20 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3