2.1.3 Deleting a user view
Procedure
1. Select the "Start-up" operating area.
2. press the "Machine data" softkey.
3. Press the "User views" softkey.
4. Press the "Manage view” softkey.
5. Select the desired view from the selection list.
6. Press the "Delete view" softkey.
or
With the final confirmation prompt you will be requested to confirm with
either "Yes" or cancel with "No".
The "User views" dialog is then redisplayed.
Just like before, as an alternative, it is possible to delete a user view under "System data"
under the following path: ../user/sinumerik/hmi/template/user_views
2.2 Plain texts for machine and setting data
Application-specific and language-dependent plain texts can be configured for machine and
setting data depending on the version [Index].
Displaying the plain texts
You set the display of the plain texts using the following display machine data:
MD9900 $MM_MD_TEXT_SWITCH Plain texts instead of MD identifier
= 1 Plain text is displayed in the table
= 0 Plain text is displayed in the dialog line
Machine and setting data
2.2 Plain texts for machine and setting data
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 27
To Next Page
Loading...
Need help?
General
