9.2.16 Configuring the "Assign Tooltips for Multitool Locations" window
<MULTITOOLPLACETOOLTIPCONFIGURATION> tag
You will find the entries for assigning tooltips in the tag
<MULTITOOLPLACETOOLTIPCONFIGURATION>. This is particularly useful if all the
multitools used on a turning machine have two locations and a fixed assignment between
multitool locations and the main spindle or the counter spindle exists, for example,
location 1 - main spindle location 2 - counter spindle. In this case, the tooltip for location 1
could be "Tool Holder for Main Spindle."
Entries Meaning
PLACE_XXX XXX stands for the multitool location number.
Tooltip Text identifier of the magazine location.
Example
<MULTITOOLPLACETOOLTIPCONFIGURATION>
<ToolTip value="TM_HOLDER_OF_MAIN_SPINDLE" type="QString" />
</PLACE_1>
<ToolTip value="TM_HOLDER_OF_COUNTER_SPINDLE" type="QString" />
</PLACE_2>
</MULTITOOLPLACETOOLTIPCONFIGURATION>
See also
Please refer to the following section for the procedure to create language-dependent text:
Creating OEM texts (Page 288
)
9.2.17 Assigning a name for magazine location types
<PLACETYPECONFIGURATION> tag
You can find entries to allocate your own location type identifiers in the tag
<PLACETYPECONFIGURATION>. Magazines
and magazine location types can be displayed
with texts in the tool lists. Instead of identifier 2, e.g. for location type 2, the configured text is
then output in the tool lists.
Entries Meaning
PLACETYPEXXX XXX stands for the number of the location type.
Text Text identifier of the location type.
Tooltip Tooltip text identifier of the location type.
Tool management
9.2 Configuring the user interface
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 271
To Next Page
Loading...
Need help?
General
