Siemens SINUMERIK 828D

<!-- End of animation definition -->
</SceneKey>
Description
</SceneKey> End of the animation definition
<!-- Existing animation as source for a new animation -->
<SceneKey source=''BoringAnimation' name=''BoringAnimationRear' mirror='
MirrorScreenX ' />
Description
<SceneKey source=''BoringAnimation' Name of an animation that is to use another
animation as its source.
name=''BoringAnimationRear' Name of the new animation based on the
source
mirror=' MirrorScreenX ' /> Mirroring in the direction of the X axis, output
is in the new animation.
<!-- Definition of a static scene (screen), (four examples) -->
<SceneKey name='Default' time='0.026' view='camiso'
type="VIEW_3D_DRILL_CUT"/>
<SceneKey name='Cut' time='0.046' view='camside' type="VIEW_SIDE"/>
<SceneKey name='Z1ink' time='0.056' view='camside' type="VIEW_SIDE"
highLightedGroup='dad_Z1ink'/>
<SceneKey name='Z1abs' time='0.066' view='camside' type="VIEW_SIDE"
highLightedGroup='dad_Z1abs'/>
Description
<SceneKeyname=’Z1abs' Screen name
time='0.066' Time of the screen on the time sensor
view='camside' Camera to be used for the screen
type="VIEW_SIDE" View type defines the view (see Section View
type (Page
222))
highLightedGroup='dad_Z1abs'/> Name of the group to be highlighted. The group
has been called "Z1abs" in Flux Studio. The
prefix "dad_" is automatically added by Flux.
<!-- End of xml file –!>
Animated elements
C.3 XML commands
SINUMERIK Integrate Run MyScreens
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3 221