STARTER drive/commissioning software
Drive commissioning for the SINUMERIK 828D can be performed using the STARTER drive/
commissioning software.
● Simple commissioning procedures which
are usually performed by field service staff (such
as activating direct measuring systems) are executed directly via the SINUMERIK 828D
user interface.
● Advanced commissioning procedures which are usually performed when the machine is
being manufactured can also be executed offline via the commissioning software used for
SINAMICS S120.
Scope of delivery and requirements
1.2 Commissioning and service tools
CNC commissioning
12 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
To Next Page
Loading...
