The tools can be oversized or fixed-location coded.
Loading via the spindle with preselection of a magazine location
You can create a
new tool directly on the spindle or, using the "load" dialog, move a tool from
the tool list, which is not located in the magazine, to the spindle.
1. A job from the tool management is always output at the interface for the loading point. You
must acknowledge this job.
2. Then manually place the tool into the spindle and deposit it in the magazine with T0 M6. A
free location is selected by the tool management in which the tool can be deposited.
The tools can be oversized or fixed-location coded.
Loading directly into the magazine
Position the relevant magazine location next to the loading position. You can create a new tool
directly on the chosen free magazine location or, using the "load" dialog, move a tool from the
tool list, which is not located in the magazine, to the selected magazine location.
1. A job from the tool management is always output at the interface for the loading point. You
must acknowledge this job.
2. Now place the tool in the magazine.
This sequence is not subject to any restrictions or constraints.
Tool management
9.5 Example: Loading/unloading
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 299
To Next Page
Loading...
Need help?
General
