Siemens SINUMERIK 828D

Program code Comment
N45 R2=$AA_MW[X] ;Save measured value in workpiece coordi-
nates at R2
N50 M0 ;Check measured value in R1/R2
N55 M30
N60 _FEHL1: MSG ("Probe does not switch!")
N65 M0
N70 M30
General function settings for measuring cycles
MD51740 $MNS_MEA_FUNCTION_MASK Measuring cycles function screen
Bit 0 Activate calibration status monitoring – workpiece measurement for measuring in automatic
Bit 1 Length reference for workpiece probe, milling technology
= 0 Tool length L1, referred to the center of the probe sphere
= 1 Tool length L1, referred to the sphere circumference of the probe sphere
Bit 2 Support of tool carriers that can be orientated for workpiece measurement with correction
in a tool
Bit 4 Workpiece probe is permanently attached to the machine and cannot be positioned
Bit 15 Workpiece measurement, traverse measuring block with path behavior G60 with exact stop
at the end of the block
Bit 16 Tool, turning technology, consideration of toolholders
Note
After changing this machine data, the probe must be re-calibrated.
MD52740 $MCS_MEA_FUNCTION_MASK Measuring cycles function screen
Bit 0 Measuring input, workpiece probe
= 0 Workpiece probe at the CNC measuring input 1, active - default
= 1 Workpiece probe at the CNC measuring input 2, active
Bit 1 Workpiece measurement, functional behavior of a third geometry axis (Y axis) when turning,
based on the machining plane G18!
Bit 2 Calculation of the correction angle with/without active orientation transformation
Bit 16 Measuring input, tool probe
= 0 Tool probe at the CNC measuring input 1, active - default
= 1 Workpiece probe at the CNC measuring input 2, active
MD54740 $SNS_MEA_FUNCTION_MASK Measuring cycles function screen
Bit 0 Repeat measurement, workpiece measurement after exceeding a dimensional difference
(parameter _TDIF) and or confidence range (parameter _TSA)
Bit 1 Repetitive measurements: workpiece measurement with alarm and cycle stop at M0
Configuring cycles
7.9 Measuring cycles and measurement functions
SINUMERIK Operate
172 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3