Siemens SINUMERIK 828D

Element values
You are currently located
under the "Active data" → <tool unit> directory in the "Commissioning"
→ "NC" →"Tool management" operating area.
You can link the following parameters with each other from the selection list via the
Assignments element:
● Spindle/gripper/loader for magazine
● Gripper/loader for spindle
● Loading point for magazine
Note
The separation as number
of locations from the magazine zero point of the affected magazine
to the internal magazine location must be defined for each magazine assignment.
Example
If, for example, tools
on a spindle must be replaced from a magazine, the following assignment
can result:
6SLQGOHB
/RFDWLRQ
WRROVSLQGOH
JULSSHUV
JULSSHU
WUDQVIHUORFDWLRQ
ORDGLQJSRLQW
ORDGLQJSRLQW
0DJD]LQH
7\SHLQGH[
6SLQGOHB
*ULSSHUB
*ULSSHUB
7UDQVIHUORFDWLRQB
/RDGLQJSRLQWB
/RDGLQJSRLQWB
0DJD]LQHB
/RDGLQJSRLQWB
/RDGLQJSRLQWB
0DJD]LQHB
7UDQVIHUORFDWLRQB
*ULSSHUB
*ULSSHUB





Parameters Assignment
Spindle/gripper/loader for
magazine
● Tool spindle location 1 for magazine (separation 0)
● Gripper location 2 for magazine (separation 0)
● Gripper location 3 for magazine (separation 0)
● Transfer location 4 for magazine (separation 0)
Gripper/loader for spindle
● Tool spindle location 1 for gripper 2
● Tool spindle location 1 for gripper 3
Loading point for magazine
● Loading point location 1 for magazine (separation 0)
● Loading point location 2 for magazine (separation 3)
Tool management
9.8 Editor for the tool and magazine management
SINUMERIK Operate
320 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3