Siemens SINUMERIK 828D Commissioning Manual

Figure 2-4 Security message for opening the TCP port
Checking the HMI time
You must correctly set the HMI time so that the secure OPC UA communication functions.
Note
The certificate
needed for secure OPC UA communication (../siemens/sinumerik/hmi/miniweb/
System/Cert/servercerts/MiniWeb_OPCUA.crt) is automatically created during the first run-up.
The start date of the validity period is set to the current date. The validity period is 30 years.
If the time is subsequently changed so that it lies outside the validity period, the secure OPC
UA communication does not function (BadCertificateTimeInvalid).
Performing a restart
Perform a hardware restart on the target systems NCU and PPU. A restart of the
SINUMERIK Operate is necessary on the PCU 50.
Setting up OPC UA components
2.2 Setup
SINUMERIK Integrate for Engineering Access MyMachine / OPC UA
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 11

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash