Note
The text files must be saved in the same way as the project files.
For example:
[System user directory]
/lng/[Text file]
[System user directory]
/proj/[Configuration file]
alsc.txt Language-dependent texts for the Siemens standard cycles
almc.txt Language-dependent texts for the Siemens measuring cycles
The text files used during program runtime are specified in the easyscreen.ini file:
[LANGUAGEFILES]
LngFile03 = user.txt ;->user<_xxx>.txt (e.g. user_eng.txt)
In this instance, the user.txt file has been chosen as an example of a text file. The name can
always
be freely selected. Depending on the language of the texts within the file, the relevant
language code must be added using the following syntax. An underscore followed by the
relevant language identifier is added after the name e.g. user_eng.txt.
Note
You
must not use LngFile01 and LngFile02 for user texts because they are already assigned
in the standard easyscreen.ini.
See also
List of language codes used in file names
(Page 203)
Format of text files
The text files must be saved in UTF-8 format.
Note
Make sure that the coding is set to UTF-8 in the editor that you are using when saving the
configuration and language files.
Format of a text entry
Syntax: 8xxxx 0 0 "Text"
Description: Assignment between text number and text in the file
Dialogs
4.2 Defining softkey menus
SINUMERIK Integrate Run MyScreens
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3 57
To Next Page
Loading...
Need help?
General
