Spectra T950 - Page 154

Chapter 4 — Configuring the Library Setting the Camera IP Address
November 2016 User Guide—Spectra T950 Library
154
4. SelectNetwork.Thenetworkconnectionsconfigurationscreendisplays.
5. SelecteitherObtain an IP address automatically (DHCP)orUse the
following IP address.
IfyouselectUse the following IP address, enterthedesiredIPaddress,
subnetmask,andgatewayaddressesasrequiredforyournetworkand
clickSave.Thefactorydefaultsare:
6. Aftersavingthenewcameraconfigurationverifythesettingsby
attemptingtoaccessthecameraatthenewIPaddress(see
UsingaWeb
Browseronpage175).
7. Ifthelibrarycontainsmultiplecameras,repeatStep1onpage152
throughStep6foreachcamera.MakearecordoftheIPaddressfor
eachcameraandtheframeinwhicheachcameraislocated.
Figure 88 Configure the camera IP addressing.
IP Address Subnet Mask Default Gateway
10.10.10.11 255.255.255.0 10.10.10.1
Important
If you set the camera to use a fixed IP address, record that address for later
reference. If you do not know the camera’s IP address, you must reset the camera to
use DHCP addressing before you can connect to it. The reset process requires
physically accessing the camera. Contact Spectra Logic Technical Support for
assistance (see
Contacting Spectra Logic on page 7).