Spectra T950 - Page 212

Chapter 6 — Configuring and Managing Partitions Confirming and Saving the Partition Settings
November 2016 User Guide—Spectra T950 Library
212
3. ClickNext.TheSavePartitionscreendisplays.
Note: TheSavePartitionscreenonyourlibrarymaybedifferentfrom
theonesshowninFigure136andFigure135.Theinformation
onthisscreenvariesdependingonthetypeofpartitionyou
configuredandtheoptionsyouchose.
4. Reviewtheinformationonthescreenandconfirmthatallsettingsare
correctforthispartition’sconfiguration.
 Iftheconfigurationinformationiscorrect,proceedtoStep5.
 Iftheconfigurationinformationisnotcorrect,dooneofthe
following:
 ClickPrevioustomovebackwardthroughtheconfiguration
screensuntilyoureachthesettingsthatneedcorrecting.Make
anynecessarycorrections,thenclickNexttomoveforward
throughthescreensandreturntotheSavePartitionscreen.
Note: Ifthescreenrequiringthecorrectionistowardthe
beginningoftheconfigurationprocess,itmaybeeasiest
toclickCancelandrepeattheentireconfiguration
process.
Asyoumovebackwardthroughtheconfiguration
screens,thevaluesareresettotheirdefaultvalues.After
youreachthedesiredscreenandmakethenecessary
changes,advancethroughthescreensandre‐enterthe
necessaryinformation.
 ClickCanceltoconfigurethepartitionagainfromthebeginning.
Figure 135 The Save Partition screen for a
cleaning partition.
Figure 136 The Save Partition screen for a
storage partition that uses a Global Spare and a
cleaning partition.