Spectra T950 - Page 272

Chapter 8 — Using the Cartridge Inventory Moving Cartridges Within a Partition
November 2016 User Guide—Spectra T950 Library
272
Example Thefollowinglinesinamovequeuefilespecifyaseriesof
moves.
3. Examinethemovequeuefilecarefullytomakesurethateachlineis
formattedcorrectlyandcontainsbothasourceandadestination.When
thelibraryparsestheuploadedfile,itwillrejectthefileifitcontains
anysyntaxerrors.
4. SavethemovequeuefileasanASCIItextfile.
Note: IfyouplantouseaUSBdevicetouploadthemovequeuefile,
savethefiletotherootofthedriveusingthefilename
MoveQueue.txt.
delimiter ;(semicolon)
:(colon)
Note: Eithercharacteris
acceptable.
Thecharacterthatseparatesthesource
fromthedestination.
destination_id
 SLOT—Thecartridgeismovedto
anemptyslotinthestoragepool.
 EE—Thecartridgeismovedtoan
emptyslotintheentry/exitpool.
 DRIVE—Thecartridgeismovedto
thespecifieddrive.
Note: Thevaluesarenotcase‐
sensitive.
Specifiesthelocationtypeforthe
destinationofthecartridgemove.
destination_num Apositiveinteger. SpecifiestheIDofthelocationtowhich
thecartridgeismoved.
 Anemptyslotintheentry/exitor
storagepoolforthepartition
 Thenumberofthedrive
Locatethe<offset>parameterforthe
desiredslotordriveinthedownloaded
inventoryfileandusethevalueasthe
destination_num.
For this variable... The possible values are... Description...
This line in the file... Moves...
BC000618L3;Slot3
Thecartridgewithbarcodelabel000618L3toslot3ofthestoragepool.
Slot10;EE5
Thecartridgeinslot10ofthestoragepooltoslot5intheentry/exitpool.
EE10;Slot15
Thecartridgeinslot10oftheentry/exitpooltoslot15inthestoragepool.
Drive3;Slot18
ThecartridgeinDrive3toslot18ofthestoragepool.
BC000618L3;Drive1
Thecartridgewithbarcodelabel000618L3toDrive1.