Spectra T950 - Page 273

Chapter 8 — Using the Cartridge Inventory Moving Cartridges Within a Partition
November 2016 User Guide—Spectra T950 Library
273
Upload and Process the Move Queue File Afteryoufinishcreatingthe
movequeuefile,usethefollowingstepstouploadandprocessthefile.
1. Logintothelibraryasauserwithsuperuseroradministrative
privileges.
2. IfyousavedthemovequeuefiletoaUSBdevice,connectthedeviceto
oneoftheUSBportsontheLCMoroperatorpanelandallowtimefor
thedevicetomountbeforeproceeding(seeConnectaUSBDeviceto
theLibraryonpage180).
3. Fromthelibraryuserinterface,selectGeneral > Inventory.The
Inventoryscreendisplaysshowingtheinformationforthelastpartition
thatwasviewedoneithertheInventoryscreenortheImport/Export
TeraPackCasesscreen.
4. Ifyouwanttouploadthemovequeuetoastoragepartitionotherthan
theonecurrentlydisplayed,selectthedesiredpartitionfromthe
Partitiondrop‐downlist,thenclickGo.
Note: Usingamovequeuefileisonlysupportedforstoragepartitions.
5. ClickAdvancedtodisplaytheoptionsforuploadingandprocessingthe
movequeuefile(seeFigure163onpage261).
6. OntheAdvancedInventoryscreen,selecttheUpload Movestab.
Important
The option to upload the move queue file from a USB device cannot be selected if
the USB device is not connected and mounted before you click Advanced on the
inventory screen.
Figure 170 Select the upload options for the move queue
file.