Spectra T950 - Page 374

Chapter 12 — Library Troubleshooting Discovering and Setting the BlueScale Vision Camera IP Address
November 2016 User Guide—Spectra T950 Library
374
4. Ifthewizarddiscoversmultiplecameras,selecttheonethatyouwant
toconfigure,thenclicktheforwardarrowtocontinue.
Notes:  ThedefaultdevicenameforthecameraisSLnnnnnn,where
nnnnnnarethelast6digitsofthecamera’s12digit
hexadecimalMACaddress.
 IfyouonlyneedtodeterminetheIPaddressforthecamera,
makeanoteofthatinformationandthenclickthebuttonin
theupperright‐handcornerofthescreentoclosethewizard.
ThecameracontinuestouseDHCPtoobtainanIPaddress.
 Ifthewizarddoesnotdiscoverthecamera,thecameramust
beresettouseDHCPaddressing.ContactSpectraLogic
TechnicalSupportforassistance(seeContactingSpectra
Logiconpage7).
 IfthecameraisconfiguredtouseDHCPandnoDHCP
serverisavailable,thecameradefaultstoIPaddress
192.168.0.99.
5. Clicktheforwardarrowtodisplaytheloginscreen.Enterthe
Administrator NameandAdministrator Password.
ThedefaultAdministrator Nameisadministrator(alllowercase,case‐
sensitive);bydefault,theAdministrator Passwordisleftblank.
Figure 235 The camera IP address shown in the Network Camera Setup Wizard.
Click arrow
to continue