Spectra T950 - Page 381

Chapter 12 — Library Troubleshooting Discovering and Setting the BlueScale Vision Camera IP Address
November 2016 User Guide—Spectra T950 Library
381
10. OntheNetworkGeneralSettingsscreen,selectGet IP address
automatically(DHCP)orUse fixed IP address.
IfyouselectUse fixed IP address, setthedesiredIP,subnetmask,and
gatewayaddressesasrequiredforyournetworkandDNS(Domain
NameServer)information.Thefactorydefaultsare:
Notes:  ThePrimaryDNSaddressisrequiredinordertousethe
emailalertordynamicDNSfeatures.
 TheSecondaryDNSisoptional.Ifprovided,itisusedifthe
PrimaryDNSisunavailable.
11. ClickSave.
12. Aftersavingthenewcameraconfigurationverifythesettingsby
attemptingtoaccessthecameraatthenewIPaddress(see
UsingaWeb
Browseronpage175).
13. Ifthelibraryhasmultiplecameras,repeatthestepsinthissectionfor
eachcamera.MakearecordoftheIPaddressforeachcameraandthe
frameinwhicheachcameraislocated.
14. Othercamerasettingscanbeconfiguredifdesired.SeetheVivotek
FD8361FixedDomeNetworkCameraUser’sManualforinformationabout
otheravailablesettings.
15. Whenyoufinishconfiguringthecamera,closeyourbrowsertoexitthe
camerasetupsoftware.
IP Address Subnet Mask Default Gateway
10.10.10.11 255.255.255.0 10.10.10.1
Figure 246 If you select Use fixed IP address, configure the
IP address for the camera.