Spectra T950 - Page 439

Chapter 14 — Maintaining the Library Updating the BlueScale Software and Library Firmware
November 2016 User Guide—Spectra T950 Library
439
6. Ifyouwanttosavetheoutputfromtheutility,usethecheckboxesat
thetopofthescreentoselectthelocation;otherwiseskiptoStep7.
7. ClickRun Utility.TheUtilityResultsscreendisplays,showingalistof
thefirmwarelevelsforallinstalledcomponents.
8. Ifrequestedtodoso,sendthisinformationtoSpectraLogicTechnical
Support(seeContactingSpectraLogiconpage7)foradvanced
troubleshooting.
Selecting this
location...
Saves the output...
Mail results to Asanattachmenttoanemailsenttothespecifiedmailrecipient.Usethedrop‐
downlisttoselecttherecipientforthereportfile.
Tosendtheemailwiththeoutputtosomeonewhoisnotalreadylistedasa
libraryuser,youmustfirst configurethatpersonasan
emailrecipient(see
ConfigureMailUsersonpage118).
Note: Donotusethedefaultautosupport@spectralogic.comemailrecipient
unlessSpectraLogicTechnicalSupportspecificallyinstructsyoutodoso.
SpectraLogicdoesnotsaveemailedresultsfilesunlesstheyarespecifically
requestedfortroubleshooting.
Save results to
Compact Flash file
TothememorycardintheLCM.
Note: SelectthisoptiononlyifspecificallyinstructedtodosobySpectraLogic
TechnicalSupport.
Save to USB ToaUSBdeviceconnectedtoaUSBportontheLCMortheoperatorpanel
(T950Bonly).
Note: ThisoptionisonlyavailableifyouinsertedaUSBdeviceinStep3on
page438.
Figure 277 The results screen for the Display Firmware
Versions utility.