RM0440 Rev 4 199/2126
RM0440 Embedded Flash memory (FLASH) for category 2 devices
228
In fast programming: FASTERR is set if one of the following conditions occurs:
– When FSTPG bit is set for more than 7ms which generates a time-out detection.
– When the fast programming has been interrupted by a MISSERR, PGAERR,
WRPERR or SIZERR.
If an error occurs during a program or erase operation, one of the following error flags is set
in the FLASH_SR register:
PROGERR, SIZERR, PGAERR, PGSERR, MISSERR (Program error flags),
WRPERR (Protection error flag)
In this case, if the error interrupt enable bit ERRIE is set in the Flash status register
(FLASH_SR), an interrupt is generated and the operation error flag OPERR is set in the
FLASH_SR register.
Note: If several successive errors are detected (for example, in case of DMA transfer to the Flash
memory), the error flags cannot be cleared until the end of the successive write requests.
Programming and caches
If a Flash memory write access concerns some data in the data cache, the Flash write
access modifies the data in the Flash memory and the data in the cache.
If an erase operation in Flash memory also concerns data in the data or instruction cache,
you have to make sure that these data are rewritten before they are accessed during code
execution. If this cannot be done safely, it is recommended to flush the caches by setting the
DCRST and ICRST bits in the Flash access control register (FLASH_ACR).
Note: The I/D cache should be flushed only when it is disabled (I/DCEN = 0).
To Next Page
Loading...
Need help?
General
