ST STM32G474 User Manual

Cyclic redundancy check calculation unit (CRC) RM0440
464/2126 RM0440 Rev 4
16.4 CRC registers
16.4.1 CRC data register (CRC_DR)
Address offset: 0x00
Reset value: 0xFFFF FFFF
16.4.2 CRC independent data register (CRC_IDR)
Address offset: 0x04
Reset value: 0x0000 0000
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
DR[31:16]
rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw
1514131211109876543210
DR[15:0]
rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw
Bits 31:0 DR[31:0]: Data register bits
This register is used to write new data to the CRC calculator.
It holds the previous CRC calculation result when it is read.
If the data size is less than 32 bits, the least significant bits are used to write/read the
correct value.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
IDR[31:16]
rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw
1514131211109876543210
IDR[15:0]
rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw
Bits 31:0 IDR[31:0]: General-purpose 32-bit data register bits
These bits can be used as a temporary storage location for four bytes.
This register is not affected by CRC resets generated by the RESET bit in the CRC_CR register

ST STM32G474 Specifications

General

Brand	ST
Model	STM32G474
Category	Microcontrollers
Language	English