WEILER E2850 REMIXING TRANSFER VEHICLE
4-5
Transporting
4
Towing/Retrieving Machine
Limp Mode
If Propel system is inoperable and engine can be started, use these instructions for emergency
situations only.
Never use limp mode to move machine farther than is required to locate the machine out of traffic
and to where repairs can be performed safely.
1. Open Limp Mode Switch cover.
2. With engine on, release Park Brake.
3. Place engine speed in low RPM.
4. Place Propel 3-Speed Control in work low.
5. Use Limp Mode Switch (1) to slowly propel machine.
Runover possible. Contact with moving parts can cut or crush.
Make sure no one is working on, underneath, or close to machine before
starting engine or moving machine. Ensure area is free of personnel. Keep
spectators away.
To Next Page
Loading...
