WEILER E2850 REMIXING TRANSFER VEHICLE
3-27
Operating Instructions
3
Preparing Machine
12. Install cleanout door cylinders to elevator.
13. Connect two hydraulic hoses assemblies (10) to
hopper dump cylinders (11).
14. Connect vibrator hose (12).
15. Install hose shield over hoses on right side of dump
hopper.
16. Connect cleanout door cylinder rod ends (13).
17. Install dump hopper cross tube (14) if removed when
hopper was setup for windrowing.
18. Adjust caster wheel height. (Refer to
"Caster Wheel
Height Adjustment"
, page 3-17.)
To Next Page
Loading...
