xx Xerox Internal Use Only Phaser 6000/6010 and WC 6015 MFP
Servicing Electrical Components
Before starting any service procedure, switch the printer power Off and unplug the
power cord from the wall outlet. If you must service the printer with power applied,
be aware of the potential for electrical shock.
Do not touch any electrical component unless you are instructed to do so by a
service procedure.
Servicing Mechanical Components
When servicing mechanical components within the printer, manually rotate the
Drive Assemblies, Rollers, and Gears.
Do not try to manually rotate or manually stop the drive assemblies while any
motor is running.
Servicing Fuser Components
This printer uses heat to fuse the image to the media. During operation, the
Fuser is very hot. Allow at least 5 minutes for the Fuser to cool before you
attempt to service the Fuser or adjacent components.
To Next Page
Loading...
Need help?
General