Xerox Phaser 6000 Service Manual

1-26 Xerox Internal Use Only Phaser 6000/6010 and WC 6015 MFP
General Information
Warm Up Time
The printer reaches the Ready state within 36 seconds after power on, transition
from Low Power to Ready, and transition from Sleep to Ready.
First Print Output Time
First Print Output Time (FPOT) is defined as the time from when the engine
receives a Start signal, until a single A4 sized page is printed and delivered to the
output tray.
Power Saver
Mode 1
The printer enters Power Saver Mode 1
when it has not received print data for the
specified time.
Fusing The system is at Pause.
Exposure
system
The system is at Pause.
Recording
system
The system is at Pause.
Cooling fan The system is at Pause.
Power Saver
Mode 2
The printer enters Power Saver Mode 2 to
reduce power consumption.
Fusing The system is at Pause.
Exposure
system
The system is at Pause.
Recording
system
The system is at Pause.
Cooling fan The system is at Pause.
Printer Color Mode
FPOT (sec.)
Ready Mode
Power Saver
Mode 2
After Power-on
Phaser
6000B
Color 29 seconds or
less
54 seconds or
less
54 seconds or
less
Black and
white
24 seconds or
less
49 seconds or
less
49 seconds or
less
Phaser
6010N,
WorkCentre
6015 MFPs
Color 27 seconds or
less
52 seconds or
less
52 seconds or
less
Black and
white
22 seconds or
less
47 seconds or
less
47 seconds or
less
Operating Modes (Continued)
Mode Condition Definition

Xerox Phaser 6000 Specifications

General

Brand	Xerox
Model	Phaser 6000
Category	Printer
Language	English