Xerox Phaser 6000 - Page 263

Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 4-15
Troubleshooting
Motor Test
(continued)
Yell ow Toner Mo tor
Magenta Toner Motor
Cyan Toner Motor
Black Toner Motor
Toner Motors
Caution: When checking the toner
motors, stop the test within
3 seconds. Executing this
test for 3 seconds or longer
may cause damage to the
printer.
DBAC ON
NOTE The use of DBAC ON, DBDC ON, TR1+
ON, TR2+ ON, TR2- ON, CR ON, MOB
LED ON, ADC LED ON, 24V ON, HV CLK
ON is prohibited to avoid shock hazards
since they are high-voltage outputs.
DBDC ON
TR1+ ON
TR2+ ON
TR2- ON
CR ON
MOB LED ON
ADC LED ON
24V ON
HV CLK ON
NVM Settings Edits, saves, loads, and prints NVM information.
Edit NVM
■ Ad0000=00000000*
■ Please wait
Displays current NVM values. Use this
function to edit NVM information.
Caution: Change NVM values only
when directed to do so by a
troubleshooting procedure.
Save NVM to ESS Save NVM
■ Save NVM MCU -> ESS
OK?
■ Saved
■ Please wait
Saves the MCU Board NVM to the IP
Board temporarily when the MCU
needs to be replaced.
LoadNVM from ESS Load NVM
■ Save NVM ESS -> MCU
OK?
■ Saved
■ Please wait
Loads the internal data saved via
NVM Settings - SaveNVM to ESS to
the new MCU Board
Print Info Provides printer configuration and settings information.
Info Page
■ Ready
■ Processing
Prints version information. The
Configuration Page contains:
■ Engine ROM Revision No.
■ MCU NVM Revision No.
Test LCD (Phaser 6010N) Test D es cr ipti o n