YOKOGAWA DL6000 Series - Page 171

Triggering
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Index
App
6-63
IM DLM6054-01EN
E-mail Content
• When Interval is set to OFF
<Subject>: The subject of the e-mail. The content of the subject is indicated below. The number
in parentheses is the number of returned NO-GO results.
GoNogo
Triggered Report (No.)
[Comment]:
Comment
[Setup Information]:
Information about GO/NO-GO conditions 1 to 4.
Logic(AND/OR)
Stop Nogo/ACQ Count (The number of NO-GO results/the acquisition count)
[Trigger Date and Time]:
The time of trigger occurrence
[Nogo/Exec Count]:
The number NO-GO results/the number of judgments performed
[Nogo Factor]:
Information, including measured values, about the conditions that returned NO-GO results
*
* Measured values are only sent for GO/NO-GO determinations based on waveform
parameters.
• When Interval is set to a value other than OFF
<Subject>: The subject of the e-mail. The content of the subject is indicated below. The number
in parentheses is the number of returned NO-GO results.
GoNogo Interval Report (No.)
[Comment]:
Comment
[Setup Information]:
Information about GO/NO-GO conditions 1 to 4.
Logic(AND/OR)
Stop Nogo/ACQ Count (The number of NO-GO results/the acquisition count)
[TimeRange]:
The amount of time that has elapsed since the start of data acquisition
[Nogo/Exec Count]:
The number NO-GO results/the number of judgments performed
[EachNogoCount]:
The number of NO-GO results for each GO/NO-GO condition (when OR logic is used).
This is not displayed when
AND logic is used.
6.15 Performing GO/NO-GO Determination with Zones