YOKOGAWA DL6000 Series

1-3
Component Names and Functions
IM DLM6054-01EN
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Index
App
Rear Panel (DLM6000)
WARNING
Do not operate without reading safety precautions in user’s manual.
CAUTION
Protect the instrument from vibration or shock when power is ON.
PROBE POWER
(
±12 V DC
)
VIDEO OUT
(
XGA
)
TRIG IN
TRIG OUT
USB
GO/NOGO
ETHERNET
100BASE-TX
ACT
LINK
LOGIC PROBE
A B C D
N200
MAIN POWER
OFF
ON
100 - 120/220 - 240 V AC
300 VA MAX 50/60 Hz
Power connector
→ section 3.3
Main power switch
→ section 3.3
USB port for PCs
Use to view the DL6000/DLM6000 display on an external
display. → section 15.3
Video signal output terminal
Use to connect the DL6000/DLM6000 to a network.
→ section 14.1
Ethernet port (optional)
Transmits GO/NO-GO result signals. → section 15.4
GO/NO-GO output connector
Use to supply power to YOKOGAWA FET probes and
current probes. → section 3.4
Probe power terminal (optional)
Use to transmit trigger signals.
→ section 15.2
Trigger output terminal
Apply external trigger signals to this
terminal. → section 15.1
External trigger input terminal
Use to connect the DL6000/DLM6000 to a PC that has a USB port.
→ Communication Interface User’s Manual, IM DLM6054-17EN
Use to save data to a PC card.
→ section 13.1
PC card slot
Logic signal input ports
Connect logic probes to these ports to observe logic
signals. → section 3.6
• DLM6000 series 16-bit models
Comes with POD A and POD C
• DLM6000 series 32-bit models
Comes with POD A, POD B, POD C, and POD D
No Auto-MDIX
1.1 Top Panel, Front Panel, and Rear Panel