1-5
Component Names and Functions
IM DLM6054-01EN
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Index
App
Trigger
EDGE Key Section 6.4
Displays a menu for configuring the edge trigger. When you press this key, the edge
trigger is selected, and the key illuminates.
ENHANCED Key Sections 6.5 to 6.11 and section 6.13
Displays a menu for configuring enhanced triggers such as qualified edge triggers, pulse
width triggers, TV triggers and serial bus triggers. When you press this key, enhanced
triggering is selected, and the key illuminates.
MODE and ACTION GO/NO-GO (SHIFT+MODE) Keys Sections 6.1 and
6.14 to 6.17
Displays a menu for setting the trigger mode and the hold-off. Press SHIFT and then
MODE to display a menu for configuring action-on-trigger and GO/NO-GO determination
settings.
B TRIG Key Section 6.12
Displays a menu for configuring the conditions for triggering on a combination of the A
(condition A set using EDGE or ENHANCED) and B triggers.
LEVEL Knob
Use this knob to set the trigger level. This knob has a push switch. You can press the
knob to automatically set the trigger level to the center of the waveform (50% of the
waveform amplitude).
TRIG’D LED
Illuminates when the DL6000/DLM6000 triggers.
Waveform Acquisition Conditions, History Waveforms, Screen
Display, and Setup Information
AUTO SETUP Key Section 4.5
Automatically configures the DL6000/DLM6000 settings to values that are appropriate for
the input signals.
SETUP MENU Key Sections 4.4 and 4.6
Displays a menu for returning all the settings to their default values, storing and recalling
setup information, etc.
On models that are equipped with the /F3 or /F4 option, a serial bus signal analysis
menu appears. For information about serial bus signal analysis, see the Serial Bus
Signal Triggering and Analysis Manual, IM DLM6054-51EN.
On models with the /G4 option, a power supply analysis menu appears.
For information about power supply analysis, see the Power Supply Analysis Manual, IM
DLM6054-61EN.
DISPLAY Key Sections 8.1 and 8.2
Displays a menu for configuring the display.
SHIFT+DISPLAY (XY) Key Section 10.4
Press SHIFT and then DISPLAY to display an XY analysis menu.
ACQUIRE Key Section 7.1
A menu for configuring waveform acquisition settings such as record length, repetitive
sampling, interleave, and interpolation appears.
HISTORY ( ) Key Chapter 11
Displays a menu for displaying and searching waveforms using the history feature.
ZOOM
ZOOM1 ZOOM2
SEARCH
DISPLAY
ACQUIRE
X - Y
AUTO
SETUP
SETUP
MENU
HISTORY
1.2 Keys and Knobs
To Next Page
Loading...
