YOKOGAWA DL6000 Series

10-41
IM DLM6054-01EN
Analysis and Searching
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Index
App
Using Qualifications to Limit a Pulse Width Search (Pulse
Qualified)
Press the Setup soft key, the Type soft key, the Width soft key, and then the Pulse Qualified soft key
to display the following menu.
Set the reference time.
Press to set the level and hysteresis.
► “Searching for Edge Using Conditions”
Set the search type to Pulse Qualified.
Set the kind of pulse to compare to the specified time ( , ).
► section 6.8
Set the search source waveform (CH1–CH4, M1–M4).
► section 6.8
Set the time width mode.
► section 6.8
Press to configure the qualifications.
► section 6.8
Searching for State Widths (Pulse State)
Press the Setup soft key, the Type soft key, the Width soft key, and then the Pulse State soft key to
display the following menu.
Set the reference time.
Press to set the level and hysteresis.
► “Searching for Edge Using Conditions”
Set the search type to Pulse State.
Set the comparison method.
True: The time for which the state conditions are met is compared with the reference time.
False: The time for which the state conditions are not met is compared with the reference
time.
► section 6.9
Press to configure the state conditions.
► section 6.9
Set the time width mode.
► section 6.9
10.9 Searching Waveforms