YOKOGAWA DL6000 Series User Manual

11-8
IM DLM6054-01EN
Explanation
You can search through the history waveforms for waveforms that meet the specified conditions,
display the detected history waveforms, and list their timestamps.
You can specify up to four search conditions. You can set the search logic for each of the search
conditions to AND or OR.
You can use the following types of zones as search conditions.
Rectangular, waveform, and polygonal zones.
Search Logic (Logic)
You can set the search logic for each of the search condition numbers from 1 to 4.
• AND: The DL6000/DLM6000 searches for history waveforms that meet all search conditions.
• OR: The DL6000/DLM6000 searches for history waveforms that meet any of the search
conditions.
Search Condition Numbers (Select)
For search conditions 1 to 4, set the source waveform, search range (the waveform zone upper and
lower limits), and the search criterion.
Search Criterion (Condition)
Select whether to detect waveforms that are in or out of the search range.
• IN: Waveforms that are inside of the search range are detected.
• OUT: Waveforms that are outside of the search range are detected.
• X: The DL6000/DLM6000 does not search for waveforms.
Search Mode (Mode)
You can select the search mode from the following options.
• Rect: You can create a rectangular zone by specifying upper, lower, left, and right limit values
and search for either all waveforms that enter or all waveforms that do not enter the
zone.
• W
AVE: You can create a zone based on a reference waveform and search for either all
waveforms that enter or all waveforms that do not enter the zone.
• Polygon:
You can load a polygonal zone that you have created on a PC and search for either all
waveforms that enter or all waveforms that do not enter the zone. (See section 6.19 for
details.)
• Parameter:
See section 11.3 for details.
Search Source Window (Window)
You can select the search source window from the following options. However, you cannot set the
search source window to XY1 or XY2 when you search using a waveform zone.
• Main:
The waveforms in the main window are searched.
• Zoom1: The waveforms in the Zoom1 window are searched.
• Zoom2: The waveforms in the Zoom2 window are searched.
• XY1: The waveforms in the XY1 window are searched.
• XY2: The waveforms in the XY2 window are searched.
Source Waveform (Trace)
Select a waveform from CH1 to CH4 or M1 to M4.
11.2 Searching for History Waveforms by Zone

YOKOGAWA DL6000 Series Specifications

General

Brand	YOKOGAWA
Model	DL6000 Series
Category	Test Equipment
Language	English