8-13
IM 701450-01E
8
Waveform Display and Information Display
Selecting the X-Y Waveform
5. Press the Select soft key to select the X-Y waveform to be set.
6. Press the Display soft key to turn ON/OFF the X-Y waveform display.
Setting the X-Axis and Y-Axis
7. Press the X Trace soft key. The X Trace menu appears.
8. Select the waveform to be assigned to the X-axis.
9. Press the Y Trace soft key. The Y Trace menu appears.
10. Select the waveform to be assigned to the Y-axis.
Setting the Display Range
11. Press the Time Range1/Time Range2 soft key to set the jog shuttle control to
Time Range1, Time Range2, or both Time Range1 and Time Range 2.
• If you select Time Range1, you can set the start point of the X-Y waveform display.
• If you select Time Range2, you can set the end point of the X-Y waveform display.
• If you select both Time Range1 and Time Range2, you can move the start and end
points of the X-Y waveform display without changing the spacing between the two.
The value of the digit being specified by Time Range1 changes.
12. Turn the jog shuttle to set the start and end points of the X-Y waveform display.
8.5 Displaying X-Y Waveforms
To Next Page
Loading...
