YOKOGAWA DL7440

10-16 IM 701450-01E
Setting the Search Conditions
4. Press the Setup soft key. The Setup dialog box opens.
Setting the Search Target Waveform, Level, Slope, and Hysteresis for Detecting
Edges
5. Use jog shuttle & SELECT to select the search target waveform (Source box).
6. Use jog shuttle & SELECT to set the level for detecting the edge (Level box).
7. Use jog shuttle & SELECT to select which slope edge, rising or falling, is to be
detected (Polarity box).
8. Use jog shuttle & SELECT to set the hysteresis (width of the level for detecting
the edge, Hysteresis box).
Setting the Edge Detection Count and the Search Start Point
9. Use jog shuttle & SELECT to set the edge detection count (Count box).
10. Use jog shuttle & SELECT to set the search start point (Start Point box).
11. Press ESC. The Setup dialog box closes.
Select the search target waveform.
Set the level for detecting the edge.
Select which slope edge, rising or falling,
is to be detected.
Set the hysteresis (width of the level for
detecting the edge).
Set the edge detection count.
Set the search start point.
Selecting the Window for Displaying the Found Waveform (Zoom Waveform
Display Frame)
This menu appears only when the zoom waveform display mode is set to Z1&Z2 or
Main&Z1&Z2. For all other modes, the menu does not appear, because the
selection is not necessary.
12. Press the Result Window soft key to select Z1 or Z2.
10.4 Searching Waveforms Using the Search and Zoom Function