10-23
IM 701450-01E
10
Analyzing and Searching Waveforms
When the determination type
is set to Pulse<Time, Pulse>Time,
or Time out
When the determination
type is set to
T1<Pulse<T2
Select the search target waveform.
Set the level used to determine
whether the polarity is high or low.
Select the polarity, high or low, used
to perform determination.
Set the search start point.
Set the pulse width used as a determination reference.
Set both the upper and lower limits of the time width onl
when the determination type is T1<Pulse<T2.
Set the hysteresis
(width of the level for detecting the edge).
Selecting the Window for Displaying the Found Waveform (Zoom Waveform
Display Frame)
13. The procedure is the same as step 12 on page 10-16.
Executing/Aborting the Search
14. The procedure is the same as steps 13 and 14 on page 10-17.
Redisplaying the Detected Waveforms
15. The procedure is the same as steps 15 and 16 on page 10-17.
Changing the Zoom Rate and Zoom Position of the Detected Waveform
16. Change the zoom rate and zoom position of the waveform according to the
procedures given in section 8.4.
Auto Scroll Search
1. Press SHIFT+ZOOM (SEARCH). The SEARCH menu appears.
Selecting the “Auto Scroll” Search Type
2. Press the Type soft key. The Type menu appears.
3. Press the Auto Scroll soft key.
10.4 Searching Waveforms Using the Search and Zoom Function
To Next Page
Loading...
