10-65
IM 701450-01E
10
Analyzing and Searching Waveforms
Turning ON/OFF the Computation Parameters
The display of the computation parameters User1 to User4 can be turned ON/OFF
separately.
ON
Displays the measurement parameter.
OFF
Does not display the measurement parameter.
Unit of Computation Parameters
Units can be assigned to computation parameters User1 to User4 using up to 4
characters.
• The type of characters that can be used are those displayed on the keyboard.
• The specified unit is displayed when the display of the measurement parameter is
turned ON.
Measurement Range
The selectable range is ±5 divisions, and the resolution is 10 divisions÷display record
length. The right end of the measurement range (Time Range2) must be greater than or
equal to the left end of the measurement range (Time Range1), and the right end of the
measurement range (Time Range4) must be greater than or equal to the left end of the
measurement range (Time Range3).
• Separate measurement ranges (Area1 and Area2) can be specified for measurement
parameter 1 and 2.
• The measurement range of dual areas may overlap.
T-R ange1
Area1 Area2
T-R ange2 T-Range3 T- Range4
T-R ange1
Area1
Area2
T-R ange2T-R ange3
T-R an ge 4
Setting the Distal, Mesial, and Proximal Values and High and Low Values
The procedure is the same as with the normal automated measurement of waveform
parameters on a single area. See section 10.6.
Note
• If measurement is not possible, *** is displayed in the measured value display area.
• If the measurement mode is Degree and the reference point is Trig, *** is displayed in the
measured value display area.
• Automated measurement cannot be performed on the logic input waveform (optional).
• For waveforms of small amplitude, correct measurements may not be possible.
• If there are two or more periods of waveform in the measurement range, the measurement is
performed on the first period.
10.8 Performing Automated Measurements of Waveform Parameters on Dual Areas
To Next Page
Loading...
Need help?
General
