13-14 IM 701450-01E
Transmission Interval (Interval for Periodic Mail Only)
You can select the mail transmission interval.
OFF, 1H, 2H, 3H, 4H, 6H, 8H, 12H, or 24H
• If you select OFF, periodic mails cannot be transmitted.
• If you are only using the action mail function, set this to OFF.
Sending a Test Mail
A test mail is sent to the address specified by Mail Address.
DL7400 Information That Is Transmitted
The following information is transmitted.
Periodic Mail
• Acquisition condition
Start/Stop, trigger condition, and acquisition counter
• Error log information
Error number and corrective action in English (up to 16 errors)
• Success/Fail information of GO/NO-GO
Only when GO/NO-GO determination is executed (see section 10.9 or 10.10)
• Results of waveform parameter measurement
Results of automated measurement of waveform parameters (see section 10.6 or
10.8) or results of automated measurement parameters of when GO/NO-GO
determination is executed using waveform parameters (see section 10.10).
Action Mail
• Acquisition condition
Start/Stop, acquisition counter
• Trigger time
• Success/Fail information of GO/NO-GO
Only when GO/NO-GO determination is executed (see section 10.9 or 10.10)
• Fail cause
Only when GO/NO-GO determination is executed (see section 10.9 or 10.10)
• Results of waveform parameter measurement
Results of automated measurement of waveform parameters (see section 10.6 or
10.8) or results of automated measurement parameters of when GO/NO-GO
determination is executed using waveform parameters (see section 10.10).
13.5 Sending Periodic or Action Mail (SMTP Client Function)
To Next Page
Loading...
