16-6 IM 701450-01E
Code Message Corrective Action Sections
841 It is not possible to make a setting that will Set the trigger mode to a mode other than Single (N). 6.1
result in the repetitive mode when the trigger
mode is set to Single(N).
842 Cannot specify A→B(N) Turn OFF the trigger gate. 6.17
and A Delay B when
the trigger gate is active.
843 Cannot set the trigger mode to Single or Change the acquisition mode or change the 6.1, 7.5
Single(N) when the acquisition mode is Average. trigger mode.
846 Cannot set the trigger mode to Single(N) Turn OFF the repetitive mode, lower T/div, or shorten 5.12, 7.4
during repetitive sampling mode. the record length.
847 Cannot set this parameter during repetitive Turn OFF the repetitive mode, lower T/div, or 5.12, 7.4
sampling mode. shorten the record length.
848 Not possible during the interleave mode. Turn OFF interleave mode. 7.3
850 Not possible in the current record length. Change the record length. 7.2
851 Cannot carry out computation at the current Change the record length. 7.2
record length.
852 The operation is not possible when waveforms Execute unload. 12.8
are loaded.
Unload the loaded files from the FILE menu.
853 Setting or executing is not possible during the Abort the search. 10.2 to 10.4
search operation.
854 Search pattern does not exist. Change the search conditions and search again. 10.4
Execute the search.
855 Settings cannot be changed or executed during Abort the search. 10.2, 10.3
the history search operation.
856 The record cannot be selected. Check the record number using Show Map. 10.2, 10.3
857 History record does not exist. History record is not possible in average mode, 7.4, 7.5
repetitive sampling mode, and roll mode.
858 Settings or executing is not possible during FFT Set Display Mode on the HISTORY menu to One. 10.1
recalculation.
Abort the operation by setting the history
Display Mode to One.
860 Cannot be configured or executed while updating Set Display Mode on the HISTORY menu to One. 10.1
the history all display. Aborted when history
display mode is set to One.
861 Cannot output color in this format. Turn OFF the color. 11.3
862 Zones cannot be edited in the following cases: Display the main window and the target waveform. 10.9
• When the main window is not displayed.
• When the target waveform is not displayed.
863 The zone waveform does not exist. Create the zone waveform. 10.9
864 The zone is being edited. To perform other Select Quit to exit zone editing. 10.9
operations, select Quit to exit zone editing.
865 Zones determination is not possible in the Display the main window and the target window and 10.9
following cases: create the zone waveform.
• When the main window is not displayed.
• When the target waveform is not displayed.
• When the zone waveform does not exist.
868 Processing statistics. To perform other Abort statistical processing. 10.7
operations, abort the statistical processing.
870 Cannot be specified. Increase the data length. 10.11
Invalid byte or bit.
871 Cannot be set when CS channels are not specified. Specify the CS channels. 10.11
16.2 Messages and Corrective Actions
To Next Page
Loading...
