16-5
IM 701450-01E
16
Troubleshooting, Maintenance, and Inspection
Code Message Corrective Action Sections
739 Analyzed data does not exist. Execute analysis. 10.11
Execute the analysis.
750 Cannot connect to the server. Check network configuration and connection. Chapter 13
751 Not yet connected to the ftp server. Check network configuration and connection. Chapter 13
752 This ftp function in not supported. – Chapter 13
753 FTP Error: Pwd Check network configuration and connection. Chapter 13
754 FTP Error: Cwd Check network configuration and connection. Chapter 13
755 FTP Error: Rm Check network configuration and connection. Chapter 13
756 FTP Error: List Check network configuration and connection. Chapter 13
757 FTP Error: Mkdir Check network configuration and connection. Chapter 13
758 FTP Error: Rmdir Check network configuration and connection. Chapter 13
759 FTP Error: Get Check network configuration and connection. Chapter 13
760 FTP Error: Put Check network configuration and connection. Chapter 13
761 FTP Error: GetData Check network configuration and connection. Chapter 13
762 FTP Error: PutData Check network configuration and connection and Chapter 13
disk space.
763 FTP Error: AppendData Check network configuration and connection and Chapter 13
disk space.
764 FTP Error: Client Handle Check network configuration and connection. Chapter 13
765 FTP Error: Others Check network configuration and connection. Chapter 13
770 Failed to acquire time from SNTP server. Check network configuration and connection. Chapter 13
Confirm the network settings and connection.
785 Cannot send data to a network printer. Check network configuration and connection. Chapter 13
786 Cannot send the e-mail message. Check network configuration and connection. Chapter 13
797 Connecting to a NetDrive. Wait until – Chapter 13
connection has been established.
Errors in Setting (800 to 899)
Code Message Corrective Action Sections
800 Illegal date/time. Set them correctly. 3.7
801 Illegal file name. Illegal character exists, or the file name is restricted 4.2
by MS-DOS. Enter a different file name.
804 Cannot change this parameter while data Press the START/STOP to stop the waveform 7.1
acquisition is in progress. acquisition first.
806 GO/NO-GO is in execution Abort GO/NO-GO. 10.9, 10.10
Please press the Abort key.
814 Duplicated label. Set a different label. 8.9
819 Cannot change when Channel Display is OFF Turn ON the channel display or set the computation. 5.1, 9.1
or Math settings are invalid.
821 Cannot change when ExtClock is active. Set the time base to Internal. 5.11
827 Illegal math expression. – 9.9
Input a correct computing equation.
829 Cannot change when Logic Mode is OFF or – 5.10
all bits of Logic Display are OFF.
830 Cannot set anything other than Low Pass for a – 9.9
Gaussian filter.
Change the Filter Type to another filter besides
Gaussian.
836 Cannot change settings during action-on-trigger. Abort abort-on-trigger. 6.16, 7.1
840 Cannot set the acquisition mode to Average Change the acquisition mode or change the 6.1, 7.5
when the trigger mode is set to Single or trigger mode.
Single(N).
16.2 Messages and Corrective Actions
To Next Page
Loading...
