YOKOGAWA DLM4000 Series User Manual

12-28
IM DLM4038-02EN
Configuring the Trend Display (Trend)
Press the Trend soft key to display the following menu.
When the Source Is Set to Fast Channel
Turns cursor measurement on or off
Turns the trend display on or off
Configure the display.
Set the display source to Fast CH.
Set user data (1, 2, 3, 4).
• Cursor1 position
• Cursor2 position
When cursor measurement is on
Set the cursor positions.
Select which trend to set
(Trend1 to Trend4).
When the Source Is Set to Slow Channel
Set the cursor positions.
Message ID
Set the
message ID.
When cursor measurement
is on
Select which trend to
set (Trend1 to Trend4).
Set the
message ID.
Turns cursor
measurement
on or off
Configure the
display.
Set the display
source to
Slow CH.
Turns the trend
display on or off
• Cursor1 position
• Cursor2 position
Setting the Message ID (Slow CH ID)
Set the message ID of the data you want to display the trend of. The selectable range of ID varies
depending on the decode display setting in the “SEARCH SENT Menu” (page 12-24) and the version
in “Setting the Serial Bus (Setup)” (pages 12-25 and 12-26), and the slow channel message type.
Version
FEB2008 and older
JAN2010
Slow channel message type Short Enhanced
Decode display setting Hex Dec Hex Dec
Selectable range 0 to F 0 to 15 00 to FF 0 to 255
12.6 Analyzing and Searching SENT Signals (Option)

YOKOGAWA DLM4000 Series Specifications

General

Brand	YOKOGAWA
Model	DLM4000 Series
Category	Test Equipment
Language	English