6241A/6242 DC Voltage Current Source/Monitor Operation Manual
4.2.6 MENU Key (Parameter Setting)
4-13
PARAMETER Loads and saves the Setting Parameters.
Parm Load Loads the setting parameters saved into the non-volatile memory.
Not displayed on the menu screen while Operate is ON.
Load0: Loads the data in non-volatile memory area 0 as the
setting parameter.
Load1: Loads the data in non-volatile memory area 1 as the
setting parameter.
Load2: Loads the data in non-volatile memory area 2 as the
setting parameter.
Load3: Loads the data in non-volatile memory area 3 as the
setting parameter.
Ld Dflt: Loads the factory shipment setting value as the setting
parameter.
Parm Save Saves the setting parameter in the non-volatile memory.
Save0: Saves the current setting parameter in non-volatile
memory area 0.
Save1: Saves the current setting parameter in non-volatile
memory area 1.
Save2: Saves the current setting parameter in non-volatile
memory area 2.
Save3: Saves the current setting parameter in non-volatile
memory area 3.
Sv Dflt: Saves the factory shipment setting value in all areas, 0
to 3.
PON. Load Selects the parameters at power ON.
P.OFF: Starts up with the parameters set when the unit was
previously turned off.
Load0: Starts up with the parameters saved in non-volatile
memory area 0.
I/F Selects and sets the interface.
I/F BUS Selects the interface.
GPIB: Selects the GPIB interface.
USB: Selects the USB interface.
GPIB Adr Sets the GPIB Address from 0 to 30.
This item does not appear when the USB interface is selected.
USB Id Sets the USB Address from 1 to 127.
This item does not appear when the GPIB interface is selected.
To Next Page
Loading...
General