ADCMT 6241A - Setting Source Value using Direct Input Mode

6241A/6242 DC Voltage Current Source/Monitor Operation Manual
2.2.1 Setting Source Value
2-19
3. Press or rotate one click counterclockwise.
The source range is automatically set to 3 V.
2.2.1.4 Setting Source Value using Direct Input Mode
Press 123... to turn to the direct mode, and set the source value by using the numeric keys and the unit key,
which are printed in green on the panel.
The following figures describe the setting procedure.
Setting numeric values
1. Press 123....
The screen is half-brightness and indicates direct input mode.
Cursor (blinking)
Cursor (blinking)
Half-brightness