6241A/6242 DC Voltage Current Source/Monitor Operation Manual
6.7.3 Remote Command List
6-32
Mea
sure-
ment
Measurement
Buffer Memory
RN n[,adr] n: 0... Releases recall execution status.
1... Sets recall execution status.
adr: Recall data number (0
to 7999)
(The data number is not changed if this set-
ting is omitted.)
Reading out the recall data by using the talker function
after the recall execution status is set performs the fol-
lowing operation.
• Increments the recall data number after the data out-
put.
• If data does not exist in the specified number, the
output becomes < EE + 8.88888E + 30 >
• Reading out does not erase the data in memory
RN? Response: RNn,adr
n : <d>
adr: <dddd>
RDN
adr1,adr2
Readout range setting for "RDT?" (GPIB only)
adr1: Number of the first read data (0
to 7999)
adr2: Number of the last read data (0
to 7999)
(0,0)(0,0)
RDN?
Response: RDN adr1,adr2 (GPIB only)
adr1,adr2: <dddd>
RDT? Read out data from specified range (GPIB only)
Response: See Section 6.6, "Data Output Format."
• If data does not exist in the specified
number, the output becomes
< EE+8.88888E+30 >
• The recall execution state is released by
executing this command.
(0)
SZ? Reads out the stored data
Response: <dddd>
0*6
RNM adr adr: Sets number of stored data targets (0 to
8000). When the measurement buffer mem-
ory is used, Bit 4 (ASM) of the Device Event
Status Register (DSR) is set when the
number of data items stored in buffer mem-
ory matches this value.
0*6
RNM? Reads the stored target address set value.
Response: RNMdddd
*6: It is not initialized by RINI or *RST command.
Item Command Description
Default Operation
Power
ON
Default
setting
During DC/
pulse
operation and
suspension
During
sweep
operation and
suspension
To Next Page
Loading...
General